Sick Linear encoders MAX series MAX48N-32A10MG0500

Sick Linear encoders MAX series MAX48N-32A10MG0500

Type:48 mm installation housing – IN cylinder mounting

Pressure pipe/End cap:10 mm / Flat

Connection type:Male connector, M12 type S (20x20 mm), 4-pin

Direction of connection:Radial

Measuring range:

Measured values:Positioning

Position (F.S.):0 mm ... 350 mm 1)

Null zone:30 mm

Damping zone:63 mm

Operating conditions:

Fluid temperature:–30 °C ... +95 °C 2)

Air humidity:90 % (Condensation not permitted)

Operating pressure PN:400 bar

Supply voltage:24 V DC (8 ... 32 V DC)

Switch-on time:< 250 ms

Switch-on current:Typ. 5.0 A / 50 μs

Measuring frequency (internal):2 ms

Transmission rate (cycle time):Steady

Accuracy Sick Linear encoders MAX series MAX48N-32A10MG0500

Setpoint tolerance:≤ ± 1 mm

Resolution:Typ. 0.1 mm (noise-free)

Hysteresis:± 0,1 mm

Repeatability:Typ. ± 0.2 mm

Linearity:Typ. ± 0.25 mm (measuring range 50 to 500 mm) 3)

Typ. ± 0.04% F.S. (measuring range from 500 to 2,500 mm)

Temperature drift:

Warming up phase:Typ. ≤ ± 0.25 mm (2 min)

In the operational status:Typ. ± 0.25 mm (measuring range 50 to 500 mm) 3)

Typ. ± 0.04% F.S. (measuring range from 500 to 2,500 mm)

Communication interface:Analog

Communication Interface detail:Current

Current output:4 mA ... 20 mA

Connection type:Male connector, M12 type S (20x20 mm), 4-pin

PIN assignment:1=V DC; 2=n.c.; 3=GND; 4=SIG

Electrical operation:

Supply voltage:24 V DC (8 ... 32 V DC)

Residual ripple:< 1% S-S

Power consumption:≤ 1.25 W

Current consumption:≤ 50 mA

Load resistance:100 ? ≤ RL ≤ 500 ?

Overvoltage protection during power-up (60 s):≤ 36 V at all poles during power-up (60 s) ≤ 48 V To GND during power-up (60 s)

Reverse polarity protection:≤ 36 V (at all poles) (ISO 16750-2)

Insulation resistance:Riso ≥ 10 MΩ, 60 s (ISO 16750-2)

Dielectric strength:500 V DC, 0 V DC (60 s) to housing (RISO ≥ 1 MΩ) (ISO 16750-2)

Short-circuit protection:VS – GND on housing